Japanese Zelkova - Zelkova serrata
Elm Family: Ulmaceae
Japanese Zelkova is a vase-shaped shade tree with resistance to Dutch Elm disease. USDA Hardiness zone 5
Insects & Spiders Home | Ulmaceae | Ulmaceae Index | Tree Encyclopedia | Trees Index | Rose Family

Japanese Zelkova
Zelkova serrata foliage; the species epithet serrata refers to the serrated leaf edges

The Japanese Zelkova is a large shade tree maturing at about 60' tall by 60' wide . It has an upright vased growth habit, hence the cultivar name "green vase." It has a rapid growth rate in youth, slowing to a medium growth rate during middle age and at maturity. Grows best in full to partial sun, and prefers moist, well-drained, deep soils but is very adaptable and urban tolerant (especially to heat, drought, pollution, poor soils, and soils of various pH levels).

Even though a member of the Elm Family, it has no disease or pest problems of significance, including Dutch Elm Disease. It may be the best replacement for the American Elm (Ulmus americana), in terms of Japanese Zelkova's resistance to Dutch Elm Disease and its vased growth habit (although it is not nearly as tall or arching as American Elm). Due to its very dense canopy when young, it should be periodically thinned to allow light flow into the interior canopy and to reduce the number of branches originating at the vase branch point.

Japanese Zelkova is very sensitive to being transplanted in autumn, and care should be taken to amend the soil, fertilize, water thoroughly, mulch adequately, and avoid salt aerosols.

Japanese Zelkova
Japanese Zelkova
Leaves: alternate, ovate, serrated to crenate margins, with a short acuminate tip and a base that is equal on both sides of the petiole. Dark green and clean summer foliage transitions to a very appealing mixture of yellow, gold, orange, burgundy, red, and wine fall color, in October and early November. 

Flower: Monoecious; yellow-green, not showy, occur in tight clusters along new stems; appearing before the leaves. Fruit: A small triangular drupe, 1/6 inch long, green and later turning brown, maturing in mid to late summer. Twig: Very slender, zigzag, red-brown in color; buds are reddish brown, cone-shaped, pointed, and widely divergent. Bark: Smooth and red-brown to gray when young with numerous lenticels; remains smooth for many years but eventually exfoliates into small patches, reddish brown in color.

Variants -- Zelkova serrata 'Green Vase' - more upright-vased in growth habit with strongly ascending branches, rapidly growing, to 65' tall by 55' wide, with yellow-orange to bronze-red fall color. Zelkova serrata 'Village Green' - more round-vased at maturity, to 45' tall by 40' wide, with wine-red fall color.

Japanese Zelkova
This specimen was started from seed 53 years ago.

DUTCH ELM DISEASE
"This disease is not of Dutch origin, but because early work on the disease was done by Dutch pathologists in the 1920s, the disease has been called Dutch elm disease (DED). In all probability the disease is of Asiatic origin.

DED is caused by a fungus called Ophiostoma ulmi (formerly Ceratocystis ulmi) that was introduced to the U.S. in the early 1930s. The American elm, Ulmus americana, is extremely susceptible and the disease has killed hundreds of thousands of elms across the U.S. All native elms are susceptible, as are European elms, but the Asiatic elms, U. parvifolia (Lace bark elm) and U. pumila (Siberian elm) are highly resistant to the disease. The disease is still a threat today, but fortunately, several resistant American elm and hybrid elm selections are available or being developed. Consult a reputable nursery or contact the Elm Research Institute for information on the availability of DED-resistant elms. Address: Elm Research Institute, Harrisville, NH 03450. Fax: 603-827-3794.

DIAGNOSIS
The disease is most easily detected during early summer when the leaves on an upper branch curl and turn gray-green or yellow and finally brown. This condition is known as "flagging," but a flag alone is not absolute assurance that the tree has DED. Brown streaks in the wood beneath the bark of affected branches is further evidence, but only laboratory isolation and identification can confirm positively that the tree has DED.

Samples should be sent to a diagnostic laboratory as soon as DED is suspected. Secure branch samples at least 1/2 inch in diameter and at least 8 inches long from a branch that shows active wilting (but is not completely dead). Wrap the sample in plastic wrap or place in a plastic bag to prevent the sample from drying out (do not add water or damp paper towels to provide moisture). The University of Illinois Plant Clinic will confirm DED for a nominal charge. The clinic is open from the first of May through mid-September.
Address: Plant Clinic, University of Illinois,
1401 West St. Mary’s Road, Urbana, IL 61801.
Phone: 217-333-0519.

 

CONTROL
Both the beetles and the fungus need to be considered for control of DED. Control is possible through prevention, early detection of the disease, and replanting with resistant elms. Valuable trees should be inspected frequently, e.g. weekly, from early May through July, and monthly through September. An infected tree may be saved by pruning out the diseased branch promptly after seeing the first "flag." A final pruning cut 7-10 feet below the lowest evidence of discolored (streaked) wood is necessary, but the saw blade should be wiped (sterilized) with 10% bleach (1 part bleach: 9 parts water) or denatured alcohol before the final cut is made. Injecting trees with systemic fungicides (see below) may be done at this time.

If a tree shows many flags or completely wilts and dies, it must be removed quickly so that beetles and root grafts do not transmit the disease further. Root grafts should be severed before removal of a diseased tree whenever possible.

Sanitation
The bark beetles breed in standing dead or dying elm trees and piles of elm wood with the bark attached. Therefore, trees that completely wilt and die are suitable for beetle reproduction and should be felled. Destroy the infected wood and bark by chipping and composting (chips must attain temperatures of at least 120 degrees F), or at a minimum, remove the bark from cut logs and let the logs dry out. Cut logs from diseased trees should not be kept for firewood unless all of the bark has been removed and there is no evidence of bark beetles. Transporting diseased elm firewood may spread DED to otherwise disease- free areas. Covering and sealing cut logs and chips in clear plastic during the summer will allow the sun to heat up the wood and is another way to kill the beetles and fungus. Prolonged sunny weather and high temperatures are necessary, however, for this method of sanitation, called "solarization," to be effective.

Chemical Protection and Therapy
At present, treatments of affected trees with thiabendazole or propiconazole-containing fungicide such as Arbortect and Alamo show promise and should only be applied by licensed, certified arborists. If properly applied, American elms may be protected for 3 years. Be aware that Arbortect is not recommended for red elm (U. rubra), and repeated injections with a systemic fungicide may damage the bark and water-conducting tissues." [1]

References
  1. The Morton Arboretum, Dutch Elm Disease, http://www.mortonarb.org/images/stories/pdf/tree_advice/dutch_elm_disease.pdf
Tree Encyclopedia | Insects & Spiders | Family Cupressaceae | Family Ulmaceae | Trees Index | Rose Family

Custom Search

 

© Red Planet Inc.